Audi 80/Avant + Technical specification + Engines + System of production of the fulfilled gases + Cooling system + Fuel tank and fuel pump + Air filter and airintaking channels + System of injection + Coupling + Transmission and transmission + Suspension bracket and steering + Brake system + Anti-blocking system of brakes - Wheels and tires Wheels Wide tires and wheels Check of pressure in tires Control of a condition of tires Replacement of a wheel Control of an inhaling of wheel bolts Balancing of wheels Purchase of new tires + Body electrical system + System of ignition + Lighting + Signalling devices + Devices and auxiliary devices + Heating and ventilation + body Elements + Search of malfunctions + Specifications
|
Replacement of a wheel
|
If the serviceable, balanced on the car wheel is established – for example after control of a condition of brakes, it needs to be tightened on a wheel nave in the same position, as before removal. For this purpose it should be noted situation on a rim (2) and a nave of a wheel (1). |
Replacement of a wheel in way – not absolutely simple business. Bolts for fastening of a wheel can be prirzhavevshy or at the last replacement of wheels in a workshop them "slammed" to percussions gaykoverty (instead of as it is necessary, to tighten the moment 110 N • м). In this case the onboard tool will not help you, the powerful key for an inhaling of bolts of fastening of wheels or a cross-shaped key with the put-on pipe piece for lengthening of the lever of force is necessary.
|
- To put the car on the parking brake and to include the first or reverse gear or parking blocking.
- On the road to turn on the alarm light system and to establish a sign of an emergency stop.
- To block wheels of the opposite side, for example stones or wooden whetstones that they did not move.
- Implant fingers into openings of a wheel cap and take off it.
- If on the car there are light-alloy wheels with secret fastening, insert a screw-driver into lateral dredging on a cap and take off a cap.
- Open a key a "confidential" bolt for fastening of wheels if that costs on your car.
- To weaken bolts for fastening of wheels – everyone approximately on a turn.
- To establish an onboard jack on the basis of the car by a bevel inside on the designated place of bottom edge of a body (section Organization of a Workplace). The jack has to enter a vertical strut of a body thus.
- On the soft earth it is necessary to enclose a plate under a jack.
- To lift the car.
- Completely to turn out bolts for fastening of a wheel.
- To remove a wheel, to put on a spare wheel. Thus the aligning pin from an onboard tool kit can help if before installation of a wheel to screw it in a bolt opening.
- To apply jellied or liquid greasing on a cone and a carving of a bolt for fastening of wheels.
- Evenly and cross to tighten bolts. Thus to turn a wheel that in one, in other party in order that it was faultlessly aligned on a nave.
- To lower the car, to dozatyanut bolts (110 N • м).
- To put on a cap. To pay attention to cut for a tire nipple.
- After a short trip to check strong landing of bolts.
|
|
|
Help: if bolts for fastening of wheels cannot be screwed in a wheel nave, the brake disk turned on a nave can be the cause. Turn it until openings coincide.
|
|
|